Hunter Lykke - Assembling the Light Kit; Light Kit Assembly Steps; Installing the Bulbs and Glass; Bulb and Glass Installation Safety

7
8
1886
1886
Installing the Bulbs and Glass
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Assembling the LIght Kit
Notch
Tab
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
2 of 3
Light Kit Screw
bag
1 of 3
Light Kit Screw
bag
2 of 2
Short Light Kit
Screw
bag
Insert the third screw, found in the hardware
bag, in place and rmly tighten all the three screws.
Carefully push all switch housing components into the switch
housing, then install the switch housing plate using two short light
kit assembly screws, found in the hardware bag.
Installing the Blades
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs Remote CradleRemote
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Fan style may vary.
Note:
Fan style may vary.
Note:
Lift the globe and align the notches
in the globe with the tabs in the
light kit.