Hunter Neutron - Preparing the Remote; Option 2: Using Screws

9
1886
1886
Ceiling Bracket Hanging Fan Wiring Installing Fan Body Blades Light Remote App
Installing the Remote Control Cradle
Option 1: Using Adhesive Strip
Option 2: Using Screws
You have two options for installing the remote cradle.
Choose which path works best for you.
Remove the cradle from
the cradle bracket.
Slide the cradle onto
the mounted bracket.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Choose your cradle
installation location.
Separate the lining
from the back of the
adhesive strip on
the cradle bracket.
Press the cradle
bracket against the
wall and hold rmly
for 30 seconds.
Preparing the Remote
Phillips
Head
Screw
Battery
Door
To access the battery
compartment, remove the
small Phillips head screw that
secures the battery door to
the transmitter assembly. The
battery should be installed
with the positive (+) side
up. Replace with a CR2032
battery when necessary.
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Replace all batteries of a set at the same
time.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove batteries from equipment which
is not to be used for an extended period
of time.
• Remove used batteries promptly.
ON
Turn Power
Fan On/Off
+ Quick Press
Light Dimming+ Long Press
+
+
Light On/Off+ Quick Press
Long Press
Long Press
Fan Updraft
Fan Downdraft
Raise Fan
Speed
Lower Fan
Speed
+ Quick Press
+ Quick Press
Key Press Function
Dimming Mode
On/Off
Long Press
Enable Beep
Disable Beep
+
+
+
Long Press
Long Press