Need help?Do you have a question about the Hunter Phenomenon and is the answer not in the manual?
Crucial safety warnings regarding electrical shock, fire risk, and personal injury.
Important cautions about wiring, parts, and FCC compliance for safe operation.
Hardware and components for installing the hanger bracket and fan wiring.
Hardware and components for attaching the ceiling canopy.
Hardware and blades required for fan blade assembly.
Components for the wall control unit and any extra downrod parts.
Hardware and parts for assembling and installing the light kit.
Extra fasteners provided for convenience, may include additional parts.
Ensures adequate clearance between fan blades and walls/floor.
Verifies the outlet box is secure and rated for fan support.
Guidance for standard and angled/vaulted ceilings, including angle limits.
Details on downrod length and angled mounting kits for steep ceilings.
Securing the ceiling bracket using machine screws.
Securing the ceiling bracket using wood screws and pilot holes.
Tip for orienting the ceiling bracket opening towards the peak on angled ceilings.
Steps for assembling and securing the downrod, including safety warnings.
Instructions for safely hanging the fan by placing the downrod ball into the ceiling bracket slot.
Connects fan wires to ceiling wires for single-switch operation.
Emphasizes the necessity of grounding the fan to prevent electrical hazards.
Guidance on neatly storing excess wires in the outlet box.
Connects fan wires for dual-switch operation (fan and light).
Connects the green, green/yellow stripe, or bare copper wires from ceiling, downrod, and bracket.
Aligning and inserting canopy screws to secure the canopy to the ceiling bracket.
Attaching blades using washers and screws, repeating for all fan blades.
Critical note on following blade instructions for proper fan function.
Installing light kit screws, connecting wiring, and securing housing components.
Ensuring light kit housing is securely attached to the mounting plate.
Installing LED bulbs into the light kit sockets.
Attaching the glass globe by aligning notches and turning clockwise.
Critical warning to ensure the glass is properly secured to prevent injury.
Steps to turn off power and install batteries into the wall control.
Connecting wires from the wall control to the switch box and fan.
Securing the wall control and its plate to the wall.
Turning power back on and details on remote transmitter pairing.
Instructions for downloading and launching the Simpleconnect app.
Follow onscreen prompts to set up your fan with the app.
Guidance on when and how to install the app if not done during initial setup.
Steps for removing the standard downrod and reassembling with a different length.
Ensuring the downrod assembly is secure by firmly pulling on the hanger ball.
Common issues and solutions for a fan that is not operating.
Steps to address and correct excessive fan wobbling.
Troubleshooting tips for fans that are making unusual noises.
Resolving erratic behavior or interference with remote controls.
Advice on safely cleaning fan finishes without causing damage.
Instructions on how to contact Hunter for warranty service and required proof of purchase.
Information on what the motor and one-year limited warranties cover.
Details on what is not covered by the Hunter fan warranty.
Explanation of how state laws affect warranty coverage.
To Next Page
General