Hunter Reveille - Canopy and Blade Installation; Securing the Canopy; Attaching Fan Blades

7
8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Canopy Screw
Installing the Bulbs and Glass
Installing the Canopy
Installing the Blades:
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the
hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy
Screw
Assembling the Light
NOTICE
If screw holes do not align
properly then rotate the canopy
180 degrees. Hanger ball shape
must match canopy opening for
correct canopy installation.
Lightly attach the blade arms to the
motor with the blade arm screws,
then securely tighten after both
screws are attached.
Repeat x5
Fan style may vary.
Note:
x15
x15
Repeat x5
bag
bag
Blade Screw
Blade Nut
Secure each blade to a blade iron as shown using the blade nuts and grommets, found in
the hardware bag, and the blade assembly screws, found in the hardware bag.
x15
Grommet
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
x10
Blade Arm Screw
Remember the screws that
you kept after removing the
shipping blocks? You need
them here.
D
I
S
C
A
R
D
K
E
E
P
!