Hunter Road Force Elite GSP9700 Series - Balancing Procedures; Wheel Lift Operation; CenteringCheck Wheel Centering Feature; Inflation Station Operation

Balancing Procedures 10
3. Balancing Proce-
dures
3.1 Wheel Lift Operation
Getting Wheel On Balancer
Slide proper collet onto spindle shaft. Position wheel lift
carriage (“lift”) at the end of the lift rail.
Press the foot pedal down to lower lift. Roll wheel onto
the lift. Raise foot pedal to raise wheel into position to
slide it on spindle. Center wheel on collet and clamp.
Keep lift under wheel and close hood. Lift will automati-
cally lower.
Removing Wheel From Balancer
Place lift under wheel and raise it to wheel. Remove
wheel clamp. Slide lift with wheel on it to end of lift rail.
Use pedal to lower lift.
3.2 CenteringCheck
®
Wheel Center-
ing Feature
CenteringCheck
®
is an inspection or verification of the
wheel’s mount to balance to identify possible centering
errors. From main balance screen, touch the “Centering-
Check” button and follow the on-screen instructions.
Print Summary
From the main balance screen, select “Print” → “Vehicle
Summary”. The Vehicle Summary screen will be dis-
played.
3.3 Inflation Station
Inflation Station provides preset tire pressure. Lift infla-
tion hose from cradle and setting screen will pop up. Set
target air pressure arrows.
Figure 17: Inflation Station
3.4 Hunter Help Video Player
On main balancer screen, touch Help → Launch Video
Player button. Select balancer topic from video menu.
Figure 18: Video Player
Use two hands to maintain control of the wheel.
Allowing the balancer to lower lift will speed up
removal.