Hunter Road Force Touch GSP9700 Series - Laser Beam and Wheel Light Check; Adjust Laser Beam Alignment

44
• Move the switch to proper location (approximately a 1/8 inch (3 mm) gap between magnets).
SWITCH
ADJUSTMENT SLOTS
1/8 INCH GAP
(3mm)
HOOD MAGNET
SWITCH
MAGNET
SWITCH
MAGNET
PROXIMITY
SWITCH
BRACKET
REAR VIEW - SAFETY HOOD NOT SHOWN
Figure 76
• Tighten the two screws previously loosened.
lower laSer Beam anD wheel light
1. Depress the foot pedal to activate the laser and wheel light. If the laser or light does not project true from the
balancer spindle, adjust the orientation of the laser beam as follows:
Figure 77
Laser light. Do not view directly with optical instruments. Class 1M laser product.
Use the two screws securing the laser to the under side of the spindle to adjust the beam. Slightly loosen
screws and move the laser within the oversized mounting holes until the distance from the laser line