Hunter Skysail - Assembling the Light; Light Kit Screw Installation; Wire and LED Module Connection

7
8
1886
1886
Assembling the Light
Fan style may vary.
Note:
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light ControlGlass
ON
Turn Power
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Installing the Bulbs and Glass
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
Insert the third screw,
found in the hardware
bag, into place and then
tighten all three screws.
Feed the wire plugs
through the center hole of
the upper switch housing,
then wrap keyhole slots
around the screws and twist
counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
3 of 6
Light Kit Screw
bag
Fan style may vary.
Note:
Lift the LED assembly and connect the
single-pin connectors to the connectors from
the fan. Connect the white wires together.
Connect the blue and black wires together.
Align the holes of LED assembly with
the holes of the upper switch housing.
Make sure all the wires from the fan
and the light kit are snug inside the
center of the light kit, not pinched in
between the upper switch housing and
the light kit or hanging out of the sides.
Insert the light kit screws, found in the
hardware bag. Tighten all three screws.
Partially install two light kit screws,
found in the hardware bag, through
the gasket halfway into the motor
housing as shown. It does not matter
which two screw holes you choose.