Need help?Do you have a question about the Hunter Sona and is the answer not in the manual?
Essential safety instructions for installation, operation, and electrical safety.
Cautions regarding ventilation use, installation limitations, and pitch requirements.
Guidelines for maintaining the fan, including cleaning and motor upkeep.
Critical safety instruction to disconnect power before servicing.
Warning against installing the ventilator above cooking equipment.
Identification of all included parts for the bath ventilator installation.
List of necessary tools that are not supplied with the ventilator.
First step: turn off the power source at the service panel.
Loosening screws on the housing as part of initial preparation.
Removing the motor/blower assembly and packing material.
Adjusting pre-loaded screw tips to be flush with housing.
Removing the wiring cover by taking out the screw.
Preparing wiring access and installing the strain relief connector.
Guidance on selecting the appropriate installation method.
Positioning depth mark and securing unit to joist/framing.
Routing wires through the strain relief for supply connection.
Diagram illustrating how to connect fan and light wires.
Installing the wiring cover plate, enclosing connections.
Connecting the 4-inch duct and venting to the outside.
Connecting the wiring harness without stressing it.
Reinstalling and securing the motor, checking for pinched wires.
Turning on power, testing the motor, and proceeding to grille attachment.
Sliding mounting rails into brackets for suspension.
Positioning depth mark and marking screw holes on joist.
Drilling pilot holes and inserting screws for rail attachment.
Attaching the mounting rails onto the inserted screws.
Tightening screws and routing wires through strain relief.
Diagram illustrating electrical connections for fan and light.
Installing wiring cover plate and connecting duct and vent.
Connecting the wiring harness without stressing it.
Reinstalling and securing the motor, checking for pinched wires.
Turning on power, testing motor, and proceeding to grille attachment.
Removing existing fan, checking opening, and cutting new opening.
Using housing as template to mark positions.
Sliding mounting rails into brackets.
Positioning depth mark and marking screw holes on joist.
Drilling pilot holes and inserting screws for rail attachment.
Attaching rails and tightening screws.
Connecting duct and vent, routing wires through strain relief.
Tightening strain relief screws.
Diagram illustrating electrical connections for fan and light.
Installing wiring cover plate and connecting wiring harness.
Reinstalling and securing the motor, checking for pinched wires.
Turning on power, testing motor, and proceeding to grille attachment.
Removing existing fan and positioning housing above ceiling.
Routing wires and attaching existing ducting.
Inserting screws into joist or framing.
Diagram illustrating electrical connections for fan and light.
Installing wiring cover plate and connecting wiring harness.
Reinstalling and securing the motor, checking for pinched wires.
Turning on power, testing motor, and proceeding to grille attachment.
Removing the thumbscrews that secure the grille.
Connecting the wiring harness to the light fixture.
Positioning strain relief bracket and aligning light fixture posts.
Attaching thumbscrews and installing light bulbs.
Aligning and locking the glass dome assembly into position.
Diagnosing and resolving fan operational issues like no power or noise.
Diagnosing and resolving issues where the light fails to operate.
Information on obtaining parts, service, and contacting customer support.
Details on limited warranty coverage, periods, and exclusions.
Conditions for voiding warranty and procedure for obtaining service.
Limitations on liability for consequential or incidental damages.
To Next Page
General
