Hunter Sona - Installation: Suspended Between Joists - Final Assembly; Wiring Harness Connection; Motor Reinstallation and Securing; Power On and Motor Test

41951-01 12/01/2013
10
B27
E1
Go to step
on page 17
to attach grille.
B22
I
I
B23
B25
Turn on the power source.
Reinstall the motor by inserting the tabs and pushing up into
position. Make sure the wires are not pinched
between the motor and the housing.
ON
OFF
B26
Test the motor. If the motor does not run,
check the plug connection.
Connect wiring harness. DO NOT ALLOW THE MOTOR TO
HANG FROM THE WIRING HARNESS.
B24
J
Secure the motor by tightening the 2 screws.