Hunter SmartWeight Pro - Operational Safety; Balancer Safety; Decal Information

To reduce the risk of electrical shock, do not use on wet surfaces or expose to rain.
Verify the appropriate electrical supply circuit is the same voltage and amperage rangs as marked on the equipment
before operang.
WARNING
DO NOT ALTER THE ELECTRICAL PLUG. Plugging the electrical plug into an unsuitable supply circuit will
damage the equipment and may result in personal injury.
When servicing the SmartWeight® Pro, power must be disconnected by removing the power cord from the electrical
outlet. Ensure that the SmartWeight® Pro power switch is in the o posion ("O" posion) before plugging the power cord
into the electrical power outlet.
2.2.3. Important Safety Instructions - Operation
To reduce the risk of re, do not operate equipment near open containers of ammable liquids (gasoline). Read and follow
all cauon and warning labels axed to your equipment and tools. Misuse of this equipment can cause personal injury
and shorten the life of the equipment. Keep all instrucons permanently with the unit. Keep all decals, labels, and noces
clean and visible. To prevent accidents and/or damage to the Balancerrecommended accessories. Use equipment only as
described in this manual. Never stand on the Balancer. Wear non-slip safety footwear when operang the Balancer. Keep
hair, loose clothing, neckes, jewelry, ngers, and all parts of body away from all moving parts. ALWAYS WEAR OSHA
APPROVED SAFETY GLASSES. Eyeglasses that have only impact resistant lenses are NOT safety glasses.
2.2.4. Important Safety Instruction - Balancers
Keep the safety hood and its safety interlock system in good working order.
Do not place any tools, weights, or other objects on the safety hood while operang the balancer.
Verify that the wheel is mounted properly and that the wing nut is rmly ghtened before spinning the wheel.
The safety hood must be closed before touching the green “START” buon, to spin the wheel.
Raise safety hood only aer wheel has come to a complete stop. If safety hood is raised before the spin is com-pleted, the
weight values will not be displayed.
The red “STOP” buon, can be used for emergency stops.
2.2.5. Decal Information & Placement - SWP
• Decal 128-1244-2 cauons the operator that spindle rotaon may occur with foot pedal depression and to keep clear of
clamping components during sha rotaon.
• Decal gives the maximum wheel diameter and maximum wheel weight for the SW Pro.
• EN/IEC Class 3R Laser Product Cercaon is shown on Decal 128-2016-2-08. This label shows the EN/IEC standards
for a Class 3R Laser Product.
• An explanaon of FDA compliance standards is shown on Decal 128-2016-2-08. FDA performance standards compli-
ance is shown on the decal.
• For units with TDC Laser, FDA standards for Class 2M laser compliance are shown on Decal 128-1155-2.
• Decal 128-381-2 warns the operator not to remove the covered of the SW Pro because of the risk of the electrical shock
and not to use below garage oor level.
• ETL cercaon standards are outlined on Decal 128-1120-2. Users are cauoned not to use the balancer below garage
level.
• A manufacturer's idencaon is also on the rear of the balancer.
SmartWeight
®
Pro Operations Manual
Page 5 of 11