Hunter SmartWeight Pro - Operation; Getting Wheel On Balancer; Remove Wheel From Balancer; Centering Check

4. Operation
4.1. Getting Wheel On Balancer
CAUTION
Use two hands to maintain control of the wheel
Slide proper collet onto spindle sha. Posion wheel li carriage (“li”) at the end of the li rail. Press the foot pedal down
to lower li. Roll wheel onto the li. Raise foot pedal to raise wheel into posion to slide it on spindle. Center wheel on
collet and clamp. Keep li under wheel and close hood. Li will automacally lower.
TIP
Allowing the balancer to lower li will speed up removal.
4.2. Remove Wheel From Balancer
Place li under wheel and raise it to wheel. Remove wheel clamp. Slide li with wheel on it to end of li rail. Use pedal to
lower li.
4.3. Centering Check
CenteringCheck® is an inspecon or vericaon of the wheel’s mount to balance to idenfy possible centering errors, thus
recognizing improper measurements. From the main balance screen, touch the “CenteringCheck” buon.
4.4. Print Summary
From the main balance screen, select “Print” → “Vehicle Summary”. The Vehicle Summary screen will be displayed.
4.5. Hunter Help Video Player
On main balancer screen, touch Help → Launch Video Player buon.
Select balancer topic from video menu.
SmartWeight
®
Pro Operations Manual
Page 9 of 11