HunterDouglas M40 TE - Electrical connections; Programming limit positions “0” and “1” MANUALLY; Programming limit positions “0” and “1” SEMI-AUTOMATICALLY; Deleting the entire memory

2 – English
English – 2
Note for consultation • In this Guide,
the numbering system is indepen-
dent and does not correspond to the
numbering stated in the text of the
complete manual. • This guide does
not replace the complete manual.
Quick Guide
Tubular motor for sun awnings
Types: M40 TE, M50 TE
“0”
5
sec.
0201 03
05
5
sec.
1
“1”
04
2
THE
END
The high limit switch (0) or the low limit switch (1) can be memorised at the beginning according to your needs.
2 - Programming limit positions “0” and “1” MANUALLY - ref. paragraph 5.3
1 - Electrical connections - ref. chapter 4
0201
x 3
03 04
THE
END
1
4 - Deleting the entire memory - ref. paragraph 5.9
C
LN
1
2
3
4
FUSE
1 - Brown: = electric ascent/descent phase.
2 - Black: = electric descent/ascent phase.
3 - Blue: = Common (usually connected to Neutral).
4 - Yellow-green(*): = Earth (equipotential bonding connec-
tion).
(*) wire not present in some versions
Press until… Limit position required (“0”) Press together (5s) Movements (n° 1) Release together
Take the awning
to the midpoint
Press until… Limit position required (“1”) Press together (5s) Movements (n° 2) Release together
Press together Movements (n° 1) Release
Press 3 times Release
02 03
01
“1”
5
sec.
04
THE
END
2
“0”
(The “RDC” function remains enabled)
3 - Programming limit positions “0” and “1” SEMI-AUTOMATICALLY - ref. paragraph 5.4
Press together (5s) Movements (n° 2) Release together
Press until… Automatic limit position (“0”) Release Press until… Limit position required (“1”)
EN
Take the awning
to the midpoint