- iv Maintenance Checklist 704-0211-215 VTX Series Maintenance and Safety Manual
Every 3 Months (Every 500 Hours)
Every 3 Months: (or after 500 hours of operation) Check the ATC oil level. . . 3 - 9
Every 3 Months: (or every 500 hours) Check the FRL air filter element . . . . . 3- 22
Every 3 Months: Drain moisture from the lines of the FRL. . . . . . . . . . . . . . 3- 22
Every 3 Months: (or every 500 hours) Replace coolant and coolant filters. . . 3- 25
Every 3 Months: (or 500 hours) Replace the coolant filter. . . . . . . . . . . . . . 3- 25
Every 3 Months: (or after 500 hours of operation) Clean the chip conveyor
tank, if equipped. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 26
Every 3 Months: Measure the ground impedance. . . . . . . . . . . . . . . . . . . . 3- 27
Every 6 Months (Every 1000 Hours or as stated)
Every 6 Months: Grease the ATC magazine chain assembly. . . . . . . . . . . . . 3 - 9
Every 6 Months: Verify the machine is sitting level. . . . . . . . . . . . . . . . . . . 3- 27
Annually (Every 2000 Hours or as stated)
Annually: (or at about every 2000 hours of use) Clean the autolube reservoir
tank and suction filter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 8
Annually: (or after 2000 hours) Replace the ATC oil. . . . . . . . . . . . . . . . . . 3 - 9
Annually: Flush, clean, and refill the spindle chiller tank. . . . . . . . . . . . . . . . 3- 14
Annually: (or after 2000 hours of operation) Replace the rotary-axis oil. . . . . 3- 30
Annually: (or after 2000 hours of operation) Replace the tilt-axis oil. . . . . . . 3- 31
To Next Page
Loading...
