Need help?Do you have a question about the Hurco VM10 and is the answer not in the manual?
General| Spindle Motor | 15 hp |
|---|---|
| Machine Type | Vertical Machining Center |
| Y-Axis Travel | 16 in |
| Z-Axis Travel | 20 in |
| Tool Capacity | 20 tools |
| Control | Hurco WinMax |
| Maximum Workpiece Weight | 1, 500 lbs |
Perform daily operational checks on the VM machine, covering various systems and components.
Perform weekly maintenance checks on the VM machine, focusing on filter and component conditions.
Perform monthly maintenance tasks for the VM machine, including inspections and system checks.
Perform maintenance every 3 months or 500 hours, including checks and replacements.
Perform maintenance every 6 months or 1000 hours, focusing on lubrication and checks.
Perform annual maintenance tasks, including flushing, cleaning, and replacing components.
Instructions and requirements for the proper installation of the machining center.
Outlines electrical service requirements for safety and equipment protection.
Specifies the requirements for compressed air supply for machine operation.
Procedures for initial testing and examination of the machine and its guarding.
Details the machine's safety circuit and basic operating rules.
Enabling and performing limited manual operations with enclosure doors open.
Guidance on proper operation, maintenance, and operator training.
Basic precautions and responsible conduct for working near the machine.
Daily checks to ensure proper operation of machine components and systems.
Details lubrication points, recommended lubricants, and fill levels.
Information on the autolube system, including its operation and maintenance.
Procedures for maintaining the autolube filter screen and fluid level.
Details on ATC lubrication, oil level checks, and chain greasing.
Procedure for cleaning tool lock pins and tool gripper fingers on the ATC arm.
Daily lubrication and cleaning of the non-motorized spindle taper.
Information on maintaining spindle chiller operation, solution levels, and filters.
Overview of the pneumatic system, including FRL units.
Information on the flood coolant system, selecting, and preparing coolant.
Procedures for checking coolant levels and replacing coolant and filters.
Procedures and intervals for warming up the machine spindle.
Monthly spindle run-in procedure for idle or new spindles.
Common symptoms and checks for problems during machine power-up.
Troubleshooting steps for when no messages appear on the console screen.
Common error messages during initialization and their remedies.
Guidance on noting and handling error messages that appear after power-up.
General corrective measures for troubleshooting machine issues.
Procedures for restoring power after an Emergency Stop activation.
How to access and interpret the Machine Diagnostics screen for error status.
Lists common operator problems with potential causes and solutions.
Troubleshooting for errors detected during the machine's power-on self-test.
Troubleshooting machine voltage and connection problems.
Diagnosing and resolving problems with the coolant system.
Troubleshooting problems related to machine motion and spindle rotation.
Details the essential information needed to order replacement parts from Hurco.
To Next Page
