VM Series Maintenance and Safety Manual 704-0212-209 Operation Requirements 2- 11
Operation and Maintenance
• Know where the Emergency Stop pushbuttons are located.
• Do not leave the machine unattended, but stand away while it is running.
Never lean on the machine.
• Be aware of all pinch points caused by the motion of the axes, table, head,
and automatic tool changer. Be aware of protruding machine parts.
• Keep the electrical cabinet doors closed while power is on. Before opening the
electrical cabinet doors, verify that the main disconnect switch has been
turned Off.
• Do not remove or bypass safety limit switches, interlocks, and other
safeguards.
• Do not start the machine unless all systems contain the proper amount and
type of lubricant.
• Make certain that all necessary guards and protective devices are in place
before operating the machine.
• If unusual sounds, smoke, heat or damaged parts occur, turn off the
machine.
Working Practices
Follow the correct service and repair procedures to ensure proper operation of the
machine, and to reduce the likelihood of serious operator injury.
Observe these basic precautions when working near a machine:
Responsible Conduct
• Follow the instructions provided when performing a maintenance task.
• Keep all parts of your body away from moving parts.
• Be alert and keep safety in mind.
• Never attempt to operate or repair a machine if you have taken strong
medication, used a prescription drug, or consumed an alcoholic beverage.
• Do not attempt to operate or repair a machine until you have read and
understood all information that pertains to the machine, including all warning
and instruction plates or decals mounted on the machine.
• Know how the machine functions, and understand its safety features.
High voltages present in the machine electrical system can cause
serious injury or death.
To Next Page
Loading...
