Hurco VM10 - Quarterly Maintenance; Semi-Annual Maintenance; Annual Maintenance

iv - VM Maintenance Checklist 704-0212-209 VM Series Maintenance and Safety Manual
Every 3 Months (Every 500 Hours or as stated)
 Check the ATC oil level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9
 Drain moisture from the lines of the FRL. . . . . . . . . . . . . . . . . . . . . . . . . . 3- 23
 Replace coolant and coolant filters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 25
 Replace the CTS coolant filter (if equipped). . . . . . . . . . . . . . . . . . . . . . . . 3- 26
 Clean the chip conveyor tank (if equipped). . . . . . . . . . . . . . . . . . . . . . . . 3- 27
 Measure the ground impedance (resistance to true earth). . . . . . . . . . . . . . 3- 29
Every 6 Months (Every 1000 Hours or as stated)
 Grease the ATC magazine chain assembly . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9
 Verify the machine is sitting level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 29
Annually (Every 2000 Hours or as stated)
 Clean the autolube reservoir tank and suction filter. . . . . . . . . . . . . . . . . . . 3 - 8
 Replace the ATC oil. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9
 Flush, clean, and refill the spindle chiller tank (if equipped).. . . . . . . . . . . . . 3- 15
 Replace the rotary-axis oil (if equipped). . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 31
 Replace the tilt-axis oil (if equipped). . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 32