www.hurom.com l 15
1. Ensure the motor has stopped completely and unplug the power cord.
2. Hold the juice outlet and the hopper with both hands and lift them up from the base.
When unplugging the power cord, hold the head part of the power cord and unplug it.
Do not touch the power cord with wet hands.
Always wash the chamber set immediately after use. Without prompt cleaning, the pulp residue may dry and crust on the parts, making it
difficult to disassemble or clean at a later time. Improper cleaning may also cause decreased performance of the appliance.
DISASSEMBLING, CLEANING AND CARE
3. Disassemble to parts as below:
1) Unlock the chamber by rotating it counterclockwise.
2) Remove the auger.
3) Remove the strainer.
4) Remove the spinning brush.
4 5
4. Rinse each part with the cleaning brush. Brush the inside and outside of each part thoroughly
under running water.
Never use scouring pads, abrasive cleaning agents, harsh detergents or sharp cleaning tools. Do not wash the parts in the dishwasher or a
dish dryer.
5. Wipe the base with a soft, damp cloth and dry thoroughly.
Do not immerse the base unit in water or any other liquid or rinse it under running water.
6. After cleaning, allow the parts to air-dry completely and store in a clean and safe place.
2 4PJ12235-HH series_V.01.indd 17 2013-06-07 오후 7:41:33
To Next Page
Loading...
Need help?
General
