Assembly instruction – Type 1
7
1. Assemble the bowl on the base.
① Make sure the bowl is all the way into
the shaft of the base.
② Twist the bowl to close.
2. Assemble the strainer +
spinning brush into the bowl.
① Make sure the red dot on the strainer
and the red dot on the bowl are aligned .
3. Place the squeezing screw in
the center of the bowl.
4. Assemble the hopper onto
the bowl.
① Make sure the arrow on the hopper
and the red dot on the bowl are aligned.
② Make sure the arrow on the hopper is
pointing to “close ”on the base.
1 2 3 4
Base
Bowl
Strainer
Hopper
Spinning
Brush
Red dot
on the
strainer
Red dot on
the Bowl
Red dot on
the bowl
Squeezing
Screw
Reverse the step carefully when
disassembling.
To Next Page
Loading...
Need help?
General
