EasyManuals Logo

Huskee 26750TSC User Manual

Huskee 26750TSC
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
Operator's Manual
26750TSC Compact Tiller
For additional information email info@ardisam.com or call 800-345-6007 M-F 8-5
TROUBLESHOOTING AND REPAIR
TROUBLESHOOTING GUIDE
While normal care and routine maintenance will extend the life
of your rototiller, prolonged or constant use may eventually
require that service be performed to allow it to continue oper-
ating properly. The troubleshooting guide below lists the most
common problems, causes and remedies.
PROBLEM REMEDY/ACTION
Engine will not start • Addgastogastank.
• Connectsparkplugwiretosparkplug
• Throttlemustbepositionedatchokeforacoldstart
Engine runs rough, oods during operation • Cleanorreplaceaircleaner
Engine is hard to start • Drainoldfuelandreplacewithfresh.Usegasstabilizeratendof
season
• Makesuresparkplugwireissecurelyattachedtosparkplug
• Drivesafetycontrollevermustbereleasedtoneutraltostartthe
engine
Engine misses or lacks power • Raisethetinesforshallowertillingbyraisingthedepth
regulator lever
• Cleanorreplaceaircleaner
• Impropercarburetoradjustment,taketoauthorized
engine service center
• Replacesparkplugandadjustgap
• Drainandrellgastankandcarburetor
Tiller moves forward during starting • Drivesafetycontrollevermustbereleasedtoneutral
to start the engine
Tiller is dicult to control when tilling
(machine jumps or lurches forward)
• Lowerenginespeedinhardground
• Lowerthedepthregulatorforgreatercontrolofthetiller
Belts squeal in forward operation •Adjustbelttension
•Replacedrivebelt
Excessive heat build up in transmission/tine area during tilling •Removevegetation
•Checktransmissionlubricationandllifneeded
WARNING
PRACTICE SAFETY AT ALL TIMES. ENGINE MUST BE
TURNED OFF AND ALLOWED TO COOL, AND SPARK
PLUG WIRE MUST BE DISCONNECTED AND SECURED
BEFORE ATTEMPTING ANY MAINTENANCE OR REPAIR.
FAILURE TO COMPLY WITH THIS SAFETY
REQUIREMENT
CAN RESULT IN SERIOUS PERSONAL INJURY TO YOU
OR BYSTANDERS.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huskee 26750TSC and is the answer not in the manual?

Huskee 26750TSC Specifications

General IconGeneral
BrandHuskee
Model26750TSC
CategoryTiller
LanguageEnglish

Related product manuals