HUSKY LINERS 8141 User Manual (English)

To Next Page

8141 Installation Ins#C2940.doc

07/27/2006

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your

factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor

liner. However, do not remove the factory-installed carpeting.

Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409

or Glass Plus

work well. Use of

Armor All

, Son-of-a-Gun

or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR TAHOE

YUKON/DENALI/ESCALADE THIRD SEAT ACCESS LINER

PART #8141 IS DESIGNED FOR USE WITH ESCALADE/YUKON/DENALI AND TAHOE’S EQUIPPED WITH 2

ROW BUCKET SEATING. THIS LINER PROTECTS THE THIRD SEAT ACCESS AREA (WALKWAY BETWEEN

ROW BUCKETS) THAT IS NOT COVERED BY THE SECOND SEAT HUSKY LINER (PART #6141). IF YOUR

VEHICLE IS EQUIPPED WITH A REAR BENCH SEAT, YOU DO NOT NEED THIS PART.

TO INSTALL LINER, FIRST FLIP BOTH 2

ROW SEATS FORWARD. ONCE LINER IS INSTALLED, FLIP 2

ROW SEATS DOWN, MAKING SURE THEY ARE SECURELY LOCKED INTO POSITION. A PHOTO OF THE

INSTALLED PART IS ON THE BACK OF THIS PAGE.

REAR OF VEHICLE (CARGO AREA)

Need help?

Do you have a question about the HUSKY LINERS 8141 and is the answer not in the manual?

HUSKY LINERS 8141 Specifications

General

Custom molded liner replaces factory mats; remove factory mats, not carpeting for correct fit. Made from tough, durable resin.

Clean with a damp cloth or sponge. Avoid slick products like Armor All® or Son-of-a-Gun®.

Part #8141 is for vehicles with 2nd row bucket seating. Does not fit rear bench seats.

Flip 2nd row seats forward, install liner, then flip seats down and ensure they are locked.