Husky 38964 - Step 3: Secure Remaining Hardware; Step 4: Tighten All Hardware

AllProductslimitedtoVehicleTowRating;seeVehicleOwnersManual
Seewww.huskytow.comforWarrantyInformation/TechSupport.© 2014HuskyTowingProducts
August13,2014‐Rev1Page‐3
3: Insert the remaining two 3/8” hex bolts (#3) and two 3/8” lock nuts (#4) through lower
holes or slots. The 3/8” hex bolts MUST be placed as close to the bottom of the trailer
frame as possible. See Fig. 3.
PLACE THE 3/8” FLAT WASHERS (#5) UNDER THE HEAD OF THE 3/8” HEX BOLTS
(#3) AND 3/8” LOCK NUTS WHEN THE SLOTS IN THE BALL PLATE ASSEMBLY (#1)
AND THE BACKING PLATE (#2) ARE USED. See Fig. 3.
4:Tighten ALL 3/8” hardware to 30 ft. lbs.
FIG. 3