Husky 38964 User Manual

AllProductslimitedtoVehicleTowRating;seeVehicleOwnersManual
Seewww.huskytow.comforWarrantyInformation/TechSupport.© 2014HuskyTowingProducts
August13,2014‐Rev1Page‐1
CLAMP-ON SWAY CONTROL
BALL MOUNT
Part # 38964
Assembly, Installation, Operation and Maintenance Instructions
Dealer / Installer:
Provide a copy of these Instructions to the end user of this product. These
Instructions provide important operating and safety information for proper
usage of this product. Demonstrate the proper use of the product with the
end user. Have the end user demonstrate that they understand the proper use
of the product.
End User:
Read and follow all instructions included in this manual. Ask your Dealer /
Installer for assistance if you do not understand the proper use of the product.
Never remove any decals from the product.
PARTS INCLUDED
# DESCRIPTION QTY # DESCRIPTION QTY
1 BALL PLATE ASSEMBLY 1 4 3/8”-16 NUT 4
2 BACKING PLATE 1 5 3/8” WASHER 4
3 3/8”-16 X 3-1/2” HEX BOLT 4
1
2
3
4
5
TRAILER FRAME
Tools Needed
9/16” WRENCH & SOCKET
TORQUE WRENCH
IMPORTANT: THIS PRODUCT IS ONLY INTENDED FOR USE WITH 2” TO 2-3/4” TRAILER FRAMES.

Husky 38964 Specifications

General

Brand	Husky
Model	38964
Category	Racks & Stands
Language	English

Summary

Product Identification and Initial Guidance

Dealer and End User Responsibilities

Provides instructions and safety information for dealers and end users regarding product usage.

Included Parts List

Lists all components provided with the clamp-on sway control ball mount.

Tools Needed for Installation

Specifies the necessary tools required for the proper installation of the sway control ball mount.

Important Trailer Frame Compatibility

Crucial information stating the product is only intended for 2" to 2-3/4" trailer frames.

Installation Steps

Step 1: Assemble Ball Plate and Backing Plate

Instructions for assembling the ball plate assembly and backing plate using hex bolts and lock nuts.

Step 2: Position Assembly on Trailer Frame

Guidance on positioning the assembly over the trailer frame and determining the correct ball placement distance.

Step 3: Secure Remaining Hardware

Details on inserting remaining bolts and placing washers for optimal mounting close to the trailer frame bottom.

Step 4: Tighten All Hardware

Specifies the torque requirement of 30 ft. lbs. for all 3/8" hardware after assembly.