Husky AM1180 - Storage; Troubleshooting

Storage
Troubleshooting
Minor problems often can be xed without calling customer service.
7
WARNING: Unplug before disassembling or servicing.
WARNING: All disassembly and repairs should be performed by qualied personnel.
WARNING: If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied persons
is order to avoid a hazard.
□
□
□
□
□
□
Before storing the air mover it should be cleaned.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the air mover.
Never immerse any part of the air mover into a liquid.
Wrap the power cord around the carry handle on the top of the unit to keep it untangled.
THE AIR MOVER SHOULD BE STORED INDOORS.
Unit will not run.
Unit has been severely jolted
causing blower wheel to rub
against housing or housing to
deform.
Dirt build up on one side of Air
Mover blower wheel.
Severe jolt has bent motor shaft.
Unit runs but Air Mover
makes loud scraping noise.
Unit runs but vibrates excessively.
□ □
□
□
□
□
□
□
□
□
□
□
□
□
□
Problem Possible Cause Corrective Action
Contact customer service.
Clean blower wheel blades.
Contact customer service.
No power to unit.
Switch not on.
Circuit breaker tripped.
Plug unit in. Check circuit breaker.
Turn on the power switch and timer knob.
Reset circuit breaker.
□
□
□
□
□
□
Unit runs but blower wheel does not turn.
Unit runs briey, then shuts off on verload.
Blower wheel is jammed
against housing.
Intake grille and /or exhaust
grille is obstructed.
Motor bearings are failing or
motor has developed an internal
electrical fault.
Contact customer service.
Remove obstruction.
Contact customer service.
HUSKYTOOLS.COM
Please contact 1-888-HD-HUSKY for further assistance.