Husky C302H - Head Bolts and General Care

23 HUSKYTOOLS.com
Please contact 1-888-43-HUSKY for further assistance.
Maintenance (continued)
Care and Cleaning
□ Drain the air tank of moisture after operation.
□ When not in use, store the compressor in a cool, dry place.
□ Disconnect the air hose and hang open ends down to allow any moisture to drain.
□ Protect the electrical cord and air hose from damage (such as being stepped on or run over). Wind them
loosely around the compressor handle.
TORQUING THE COMPRESSOR HEAD BOLTS
The air compressor pump head bolts should be kept
properly torqued. Check the torques of the head bolts
after the first five hours of operation.
□ Torque to 14-16 ft-lbs. (19–21.7 Nm).
C302H_HUSKY_manual_5-15-ENG.indd 23 6/10/15 12:05 PM