Husky H200BND - Troubleshooting; Air Leaks; Tool Operation Issues

TROUBLESHOOTING
Air leak near the top of the tool or
in the trigger area
PROBLEM POSSIBLE CAUSE SOLUTION
Loose screws
Worn or damaged O-rings or
seals
Tool does nothing or operates
sluggishly
Tool jams frequently
Tighten screws
InstallOverhaulKit
Inadequate air supply
Inadequate lubrication
Worn or damaged O-rings or bumper
InstallOverhaulKit
Verify adequate air supply
Lubricate tool
InstallOverhaulKit
Air leak near the bottom of the
tool
Worn or damaged O-rings or bumper
Incorrect fasteners
Damaged fasteners
Loose magazine
Dirty magazine
Worn or damaged driver
Verify that fasteners are the correct size
Replace fasteners
Tighten screws
Clean magazine
InstallDriverMaintenanceKit
14 - English
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 16
AFTER SPANISH LANGUAGE SECTION.