Assembly
Attaching the bottle opener
CAUTION: Do not over tighten the bolts.
1
Attaching the cabinet handle
□ Position the cabinet handle (C) over the holes on the
cabinet (B).
□ Attach with the bolts (CC) and tighten with supplied
hex key (DD).
Attach with the bolts (CC) and tighten with supplied
hex key (DD).
NOTE:
The holes in the cabinet are tapped and do not
require nuts.
NOTE:
There are holes to mount handle on both sides
of cabinet, but only one handle is provided.
2
B
C
F
CC
CC
□ Position the bottle opener (F) over the holes on the
cabinet (B).
□
Attaching the casters
3
B
C
6
□ Be sure the drawers are locked and lay the cabinet (B) on its top. Use packaging material to protect the finish.
□ CASTER CONFIGURATION #1: UNIT WILL PRIMARILY BE STATIONARY
•Attach 2 swivel casters (E) to the cabinet (B), on the same side as the handle (C) and attach the other 2 swivel casters (E)
to the opposite side of the cabinet (B). Insert bolts (AA) through washers (BB) and swivel caster (E) into the cabinet (B).
•Attach 2 fixed casters (D) to the center of the cabinet (B) by inserting bolts (AA) through the washers (BB) and the fixed
casters (D) into the cabinet (B).
CAUTION: Do not over tighten the bolts.
CAUTION:
Two people are recommended for assembly.
To Next Page
