To Next Page
A
andrewparkerJul 27, 2025
What to do if my Husky NANOOK has no power?
- WwalkerdanielleJul 27, 2025
If your Husky Vacuum Cleaner has no power, first ensure the power level complies with the unit’s electrical requirements. Check that the electrical cord is plugged directly into a power outlet and verify the breaker on your electric circuit panel. The unit has a mini breaker (button on the side of the motor housing) to protect against overload; push the button to reset it. If it trips again, contact a local service center. If these steps don't solve the problem, using a screwdriver with a rubber handle, touch both pins of the low voltage terminals on the side of the motor housing to short circuit the pins. If the unit starts, the issue is with the low voltage wiring. Finally, check if the 24 Volts circuit is adequately connected by checking each inlet.
General
