Why does my Husqvarna 2014 FC 250 EU have high oil consumption?
F
Felicia MillerJul 31, 2025
High oil consumption in your Husqvarna Motorcycle can stem from several factors. Start by checking the engine vent hose for bends and ensure it's properly routed, replacing it if needed. Also, verify that the engine oil level isn't too high. If the oil is too thin, change it along with the oil filter and clean the oil screen. Lastly, worn piston and cylinder components can also contribute to high oil consumption; in this case, determine the mounting clearance.
B
Brenda ReillyAug 6, 2025
What to do if the FI warning lamp (MIL) lights up on my Husqvarna 2014 FC 250 EU?
K
Kim ArnoldAug 6, 2025
If the FI warning lamp lights up or flashes on your Husqvarna Motorcycle, it indicates a defect in the fuel injection system. You should stop the motorcycle and use the blink code to identify the faulty part. Also, inspect the cabling for any damage and check the electrical plug-in connections for corrosion and damage.
M
Mark ChavezAug 10, 2025
How to troubleshoot engine not cranking (electric starter) on Husqvarna 2014 FC 250 EU?
M
marcusellisAug 10, 2025
If your Husqvarna Motorcycle engine cannot be cranked using the electric starter, several issues could be the cause. You may need to follow the start procedure. Other potential causes include a discharged battery (recharge or check the charging voltage, open-circuit current, or stator winding of the alternator), a burned-out main fuse (replace the fuse), a faulty starter relay (check the relay), or a faulty starter motor (check the motor).
H
Harry McdonaldAug 15, 2025
Why does my Husqvarna 2014 FC 250 EU engine overheat?
S
scottwilliamsonAug 16, 2025
If your Husqvarna Motorcycle engine overheats, it could be due to several reasons. There might be too little coolant in the cooling system, so check for leakage and the coolant level. Ensure there's enough air stream and switch off the engine when standing. Also, clean the radiator fins if they are very dirty. Other possible causes include foam formation in the cooling system (drain and refill the coolant) or a bent radiator hose (replace the hose).
A
arielpalmerAug 20, 2025
What to do if Husqvarna 2014 FC 250 EU engine turns but doesn't start?
M
Meredith WaltersAug 21, 2025
If your Husqvarna Motorcycle engine turns but does not start, first ensure the fuel hose connection is properly joined. Then, check the fuel screen in the fuel hose connection for clogs, and replace it if necessary. Also, verify that the idle speed is correctly set. Clean and dry the spark plug if it's oily or wet, and adjust the plug gap to 0.8 mm (0.031 in) if it's too wide. Inspect the wiring harness for frayed short circuit cables and check the electrical system. If these steps don't resolve the issue, there might be a defect in the fuel injection system.
W
welchbrettAug 26, 2025
Why does my Husqvarna 2014 FC 250 EU Motorcycle engine have too little power?
A
Albert DennisAug 26, 2025
If your Husqvarna Motorcycle engine has too little power, the air filter might be very dirty, so clean the air filter and air filter box. Another cause could be a very dirty fuel filter, so change the fuel filter. A defect in the fuel injection system could also be the reason. Check the exhaust system for damage, and if it's leaky, deformed, or has too little glass fiber yarn filling in the main silencer, change the glass fiber yarn filling. Lastly, ensure that the valve clearance is properly adjusted.
To Next Page
General
