Husqvarna 2016 FE 250

Questions and Answers

J
Johnny RasmussenAug 17, 2025
What causes high oil consumption in my Husqvarna 2016 FE 250 Motorcycle?
- S
  susan54Aug 17, 2025
  High oil consumption in your Husqvarna Motorcycle can be attributed to several factors: * Bent engine vent hose: Ensure the vent hose is routed without bends, or replace it if necessary. * Excessive engine oil level: Check the engine oil level. * Engine oil viscosity too low: Change the engine oil and oil filter, and clean the oil screen. * Worn piston and cylinder: Measure the piston/cylinder mounting clearance.
C
Christina ClarkAug 19, 2025
What to do if the FI warning lamp (MIL) lights up on my Husqvarna 2016 FE 250 Motorcycle?
- W
  William JensenAug 20, 2025
  If the FI warning lamp (MIL) lights up or flashes on your Husqvarna Motorcycle, stop the motorcycle and identify the faulty part using the blink code. Also, check the cabling for damage and the electrical plug-in connectors for corrosion and damage. It may be necessary to read out the fault memory using the Husqvarna Motorcycles diagnostics tool to properly diagnose the issue.
R
Ronald MolinaAug 22, 2025
Why my Husqvarna 2016 FE 250 Motorcycle engine cannot be cranked with the electric starter?
- L
  lriveraAug 22, 2025
  If your Husqvarna Motorcycle engine cannot be cranked using the electric starter, possible causes include: * Operating error: Ensure you are following the correct start procedure. * Discharged battery: Charge the battery, and check the charging voltage, closed current, and the stator winding of the alternator. * Blown main fuse: Replace the main fuse. * Defective starter relay: Check the starter relay. * Defective starter motor: Check the starter motor.
P
Phillip TerrellAug 28, 2025
Why does my Husqvarna Motorcycle engine die while riding?
- J
  John ChanAug 28, 2025
  If your Husqvarna Motorcycle engine dies during a trip, it could be due to: * Lack of fuel: Refuel the motorcycle. * Blown fuse 1 or 2: Replace the affected fuse. * Low coolant level: Check the cooling system for leaks and ensure the coolant level is adequate. * Insufficient airflow: Switch off the engine when stationary.
D
Duane WilliamsAug 31, 2025
Why does my Husqvarna 2016 FE 250 have low power?
- S
  Seth WileyAug 31, 2025
  If your Husqvarna Motorcycle engine has too little power, check the following: * Contaminated air filter: Clean the air filter and air filter box. * Dirty fuel filter: Change the fuel filter. * Dirty fuel screen: Change the fuel screen. * Fuel injection system defect: Read out the fault memory using the Husqvarna Motorcycles diagnostics tool. * Leaky exhaust system: Check the exhaust system for damage and replace the glass fiber yarn filling of the main silencer if needed. * Insufficient valve clearance: Adjust the valve clearance. * Defective ignition system: Check the ignition coil's secondary winding, spark plug connector, and the stator winding of the alternator.
S
Sarah SheaSep 2, 2025
Why does my Husqvarna 2016 FE 250 engine not speed up correctly?
- M
  Mr. Dennis BaileySep 2, 2025
  If your Husqvarna Motorcycle engine does not speed up properly, the issue could stem from: * A defect in the fuel injection system: This requires reading the fault memory using the Husqvarna Motorcycles diagnostics tool. * A defective ignition system: Inspect the ignition coil's secondary winding, check the spark plug connector, and examine the stator winding of the alternator.
J
Juan BonillaSep 5, 2025
What causes my Husqvarna Motorcycle engine to overheat?
- S
  Shawn BryantSep 5, 2025
  If your Husqvarna Motorcycle engine overheats, consider the following potential causes: * Foam formation in the cooling system: Drain and refill the coolant. * Bent radiator hose: Replace the radiator hose. * Defective thermostat: Check the thermostat. The guideline opening temperature is 70 °C (158 °F). * Defect in the radiator fan system: Check the radiator fan fuse (fuse 4) and the radiator fan itself.
E
Elizabeth RobertsSep 7, 2025
Why are the lights not working on my Husqvarna 2016 FE 250 Motorcycle?
- J
  Justin LewisSep 7, 2025
  If the high beam, low beam, parking light, tail light, and license plate lamp are not working on your Husqvarna Motorcycle, it is likely that Fuse 3 is blown. Replace the fuse.
A
Ashley HaynesSep 12, 2025
What causes a Husqvarna Motorcycle battery to discharge?
- S
  Steven KruegerSep 12, 2025
  If your Husqvarna Motorcycle battery is discharged, it could be due to: * The alternator not charging the battery: Check the charging voltage and the stator winding of the alternator. * An undesired power consumer: Check the closed current.
K
Kelly Weaver MDSep 13, 2025
Why are speedometer, horn, brake light, turn signal, and radiator fan not working on my Husqvarna 2016 FE 250?
- K
  kristenwilsonSep 13, 2025
  If the speedometer, horn, brake light, turn signal, and radiator fan are not working on your Husqvarna Motorcycle, it's likely that Fuse 4 is blown. Replace the fuse.