Need help?Do you have a question about the Husqvarna 26 L and is the answer not in the manual?
Lists common engine problems and corresponding sections for solutions.
Instructions for correctly installing the protective shield.
Steps for correctly feeding the trimmer line into the head.
Procedures for attaching and detaching the trimmer head.
Guidance on inserting spools and line into the trimmer head.
Steps to reassemble the trimmer head after maintenance or repair.
Detailed procedure for lubricating the drive shaft.
Steps for installing the throttle cable correctly.
Procedure for removing the throttle cable from the unit.
Guide for replacing the spark plug in the engine.
Information on locating and servicing the ignition switch.
Steps to test for spark to diagnose ignition issues.
Procedure to check engine acceleration performance.
Procedure to check engine deceleration performance.
Steps for removing and cleaning the air filter.
General steps for carburetor adjustment and preparation.
Detailed instructions for adjusting the carburetor settings.
Procedure for adjusting the high speed fuel mixture.
Procedure for setting the engine's idle speed.
Procedure for adjusting the low speed fuel mixture.
Overview of the clutch system and its components.
Steps for removing and installing the clutch assembly.
Procedure for removing the starter rope from the assembly.
Steps for installing a new starter rope into the assembly.
Procedure for replacing the cylinder and piston.
Steps for replacing the piston rings.
Procedure for replacing the reed valve assembly.
General procedures related to the crankcase.
Steps for removing the crankshaft from the crankcase.
Procedure for replacing bearings in the crankcase.
Steps for replacing seals in the crankcase assembly.
To Next Page
General
