Need help?Do you have a question about the Husqvarna 32 L and is the answer not in the manual?
General| Power Output | 0.9 kW |
|---|---|
| Engine Type | 2-stroke |
| Engine Displacement | 32.6 cc |
| Displacement | 32.6 cc |
| Shaft Type | Straight |
Details the limited warranty coverage period and terms for Husqvarna products.
Outlines Husqvarna's commitment to repair or replace defective components.
Lists specific parts and conditions excluded from warranty coverage.
Defines conditions that void the warranty and limitations on liability.
Specifies customer duties for maintaining and operating the product.
Explains the steps and requirements for claiming warranty service.
Provides common issues and references for troubleshooting engine performance.
Instructions for correctly installing the safety shield for operator protection.
Step-by-step guide on how to correctly load and feed trimmer line.
Procedures for attaching and detaching the trimmer head from the drive shaft.
Instructions on how to install a spool with trimmer line.
Steps for putting the trimmer head back together after maintenance.
Guidance on applying lubricant to the drive shaft for smooth operation.
Steps for correctly routing and securing the throttle cable.
Instructions for disconnecting and removing the throttle cable.
Procedure for removing and installing a new spark plug.
Steps to diagnose ignition system issues by checking for spark.
Information on locating and replacing the ignition switch on various models.
Procedure to test and ensure smooth engine acceleration.
Procedure to verify the engine returns to idle smoothly.
Instructions for removing, cleaning, and reinstalling the air filter.
Detailed steps for adjusting carburetor settings for optimal performance.
Procedure to set the high-speed mixture screw for correct engine speed.
Steps to adjust the idle speed screw for proper engine idling.
Procedure to adjust the low-speed mixture screw for engine stability.
Steps for removing and reinstalling the clutch assembly.
Instructions on how to remove the starter rope and related components.
Steps for correctly installing a new starter rope and spring.
Guide on how to replace the cylinder and piston assembly.
Procedure for replacing the piston ring on the cylinder.
Instructions for removing and replacing the reed valve.
Steps to remove the crankshaft from the engine case.
Guidance on how to replace bearings in the engine assembly.
Instructions for replacing seals in the engine crankcase.
To Next Page
