Need help?Do you have a question about the Husqvarna 32 LC and is the answer not in the manual?
Covers limited warranty, obligations, exclusions, exceptions, and customer responsibilities.
Outlines the process for obtaining warranty service and support.
Provides guidance on common engine and trimmer problems and their potential solutions.
General notes and reminders related to troubleshooting procedures.
Overview of engine type, displacement, RPM, ignition, carburetor, and other key model specifications.
Step-by-step instructions for correctly attaching the trimmer shield.
Important warnings and cautions regarding shield installation and operation.
Procedures for installing, removing, feeding line, and reassembling the trimmer head components.
Steps to remove and inspect the drive shaft for damage or wear.
Instructions for lubricating and reassembling the drive shaft.
Details lubrication steps and references throttle cable removal for procedures.
Step-by-step guide for installing the throttle cable correctly.
Important considerations and warnings during throttle cable installation.
Detailed instructions for removing the throttle cable from the trimmer.
Procedures for spark plug replacement, ignition switch service, wiring, and spark checks.
Covers acceleration/deceleration checks and air filter maintenance procedures.
Guide to performing carburetor adjustments, including preparation, idle, low, and high speed mixture.
Procedures for clutch removal, starter assembly, rope handling, and safety.
Steps for replacing the cylinder and piston, including muffler and head bolt removal.
Details on removing and installing new piston rings with necessary precautions.
Procedures for replacing the reed valve and crankcase gasket.
Procedures for removing crankshaft, replacing bearings, and installing seals.
To Next Page
General
