7. Turn the guide bar daily to extend its life cycle.
Troubleshooting
User interface
LED screen Possible faults Possible solution
The warning in-
dicator flashes.
Chain brake is
engaged.
Disengage the chain brake.
Temperature
deviation.
Let the product to cool down.
Overload. The
saw chain can
not move.
Release the saw chain.
The power trig-
ger and the
start/stop but-
ton are pushed
at the same
time.
Release the power trigger to activate the product.
Green activate
LED flashing.
Low battery
voltage.
Charge the battery.
The warning in-
dicator is on.
Service. Speak to your servicing dealer.
Battery
Problem
Possible faults Possible solution
Green LED flashes. Low battery voltage. Charge the battery.
Red error LED flashes. The battery is empty. Charge the battery.
Temperature deviation. Use the battery in temperatures between
-10°C (14°F) and 40°C (104°F).
Overvoltage. Remove the battery from the battery charger.
Red error LED comes on. Cell difference is to much (1V). Speak to your servicing dealer.
32 1155 - 002 - 13.05.2020
To Next Page
Loading...
