1. Information and warning decal
2. Felling direction mark
3. Air purge bulb
4. Cylinder cover
5. Start/stop switch
6. Throttle trigger lockout
7. Rear handle
8. Choke control
9. Fuel tank
10. Carburetor adjustment screws
11. Starter rope handle
12. Starter housing
13. Chain oil tank
14. Muffler
15. Chain brake and front handguard
16. Front handle
17. Decompression valve
18. Switch for heated handles (346XPG, 353G)
19. Product and serial number plate
20. Right hand guard
21. Throttle trigger
22. Clutch cover
23. Oil pump adjustment screw
24. Chain tensioning screw
25. Chain catcher
26. Spiked bumper
27. Guide bar
28. Saw chain
29. Bar tip sprocket
30. Transportation guard
31. Operator′s manual
32. Combination wrench
33. Vibration damping system, 3 units
34. Brake band
Symbols on the product
Warning! Be careful and use the product
correctly. This product can cause serious
injury or death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Stop.
This product complies with applicable EC
Directives.
Noise emissions to the environment
according to European Directive
2000/14/EC and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". Noise emission data can be found
on the machine label and in
Technical
data on page 34
.
Warning! Kickback can occur when the
guide bar tip touches an object. A
kickback causes a lightning fast reverse
reaction that throws the guide bar up and
in the direction of the operator. Can cause
serious injury.
Choke.
Air purge bulb.
Decompression valve.
Adjustment of the oil pump.
Fuel.
Chain oil.
If your product has this symbol it has a
catalytic converter.
Chain brake, engaged (right). Chain
brake, disengaged (left).
If your product has this symbol it has
heated handles.
1533 - 001 - 22.01.2021 3
To Next Page
Loading...
