English – 41
Technical data
Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chain saw models 357XP, 357XPG, 357XP E-tech,
357XPG E-tech, 359, 359 E-tech, 359G and 359G E-tech. These chain saw models equipped with either of the listed
bar and saw chain combination(s), fulfills the requirements according to ANSI B175.1-2000 (Gasoline Powered Chain
Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw models Husqvarna 357XP, 357XPG, 357XP E-tech, 357XPG E-tech, 359, 359 E-tech, 359G and 359G E-
tech met the kickback performance requirements of ANSI B175.1-2000 when tested with the combinations of bars and
saw chains listed below. The saw chain Husqvarna H30 is also classified as a low kickback saw chain since it met the
requirements for low kickback saw chain outlined in ANSI B175.1-2000. We recommend to use only the listed
combinations of bars and chains for chain saw models Husqvarna 357XP, 357XPG, 357XP E-tech, 357XPG E-tech, 359,
359 E-tech, 359G and 359G E-tech. Other chain saw models may not meet the kickback requirements when equipped
with the listed guide bar and saw chain combinations.
Note: For the saw chains above (if available) you are free to choose between 0.050" or 0.058" gauge drive links for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Guide bar Saw chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13
0.325 0.050 10T Husqvarna H30
56
15 64
16 66
18 72
20 78
13
0.325 0.058
10T
Husqvarna H25
56
15 64
16 66
18 72
20 12T 78
15
3/8" 0.058 11T Husqvarna H42
56
16 60
18 68
20 72
24 84
0,050” H30 H22
0.058” - H25
To Next Page
Loading...
Need help?
General