Husqvarna 357XP/XPG - Saw Chain Filing and File Gauges

English – 41
Technical data
Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for chain saws Husqvarna 357 XP, 357 XPG, 357 XP E-tech,
357 XPG E-tech, 359, 359G, 359 E-tech and 359G E-tech. The combinations of powerhead, guide bar and saw chain
meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose guide bar having the same length and nose radius as a sprocket-nose guide bar may be considered to have
equivalent or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed guide bars and saw chains or ”Type C Low-Kickback Saw Chains”
which are available at your dealer.
Note: For the saw chains above (if available) you are free to choose between 0.050" or 0.058" gauge drive links for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Guide bar Saw chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13
0.325 0.050 10T Husqvarna H30
56
15 64
16 66
18 72
20 78
13
0.325 0.058
10T
Husqvarna H25
56
15 64
16 66
18 72
20 12T 78
15
3/8" 0.058 11T Husqvarna H42
56
16 60
18 68
20 72
24 84
0,050” H30 H22
0.058” - H25