CRANKCASE AND CRANKSHAFT
GB
44 – English
4. Locate the guide pegs in the clutch side crankcase half,
grease and locate the gasket. See fig. 12.
Fig. 12
Fig. 13
Fig. 14
5. Use tool 502 50 30-14 and pull on the flywheel side
crankcase half. Pull until the gasket is clamped between
the two halves. See fig. 13.
6. Insert the six bolts and tighten them in rotation. Tighten
them finally to 8 Nm. See fig 14.
NOTE!
Ensure that excess gasket material does not
fall into the crankcase.
9. Refit the following components:
A. Tank unit. See page 35.
B. Piston and cylinder. See page 39.
C. Silencer. See page 14.
D. Carburettor. See page 31.
E. Lubrication system. See page 25.
F. Centrifugal clutch. See page 23.
G. Electrical system. See pages 19-21.
H. Recoil starter. See page 17.
I. Chain and guide bar. See instruction book.
10.If a new crankshaft has been fitted the saw must be run
in for 3-4 hours at the carburettor base settings (H=1 and
L=1). See carburettor settings on page 32 and 33.
7. Cut off excess gasket at the level of the cylinder seating
plane.
8. Refit the carburettor space bottom plate with the four
bolts. Tighten to 5 Nm.
NOTE!
Continuing to pull with the assembly tool
after the gasket is clamped will damage the
crankshaft.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
