English – 41
TECHNICAL DATA
Recommended cutting equipment
Chain saw model(s) Husqvarna 565, 572XP and 572XPG has been evaluated for safety according to EN-ISO 11681-1
(Machinery for forestry - Portable chain saw safety requirements and testing) and fulfills the safety requirements when
equipped with the below listed guide bar and saw chain combination(s).
We recommend only to use the listed guide bar and saw chain combination(s).
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the number of teeth (e.g. 10T). For solid bars the nose radius is
defined by the size of the nose radius. For a given guide bar length, you may use a guide bar with smaller nose radius
than listed.
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct filing angles. We recommend always using a Husqvarna file gauge
to restore the sharpness of the saw chain. The part numbers are given in the table below.
If you are not sure of how to identify what saw chain you have on your chain saw, please visit www.husqvarna.com for
more information.
Guide bar Saw chain
Length, inch Pitch, inch Gauge, mm
Max. nose
radius
Type
Length, drive
links (no.)
15
3/8 1,5
11T
Husqvarna H42
Husqvarna C85
56
16 60
18
34 mm
68
20 72
24 84
28
92
C85
To Next Page
Loading...
