English – 7
CONTROLS
1. Dash panel (fig. 11)
a. throttle control lever
b. ignition switch
c. headlight switch
d. switch MAN-AUTO, collector fill gauge
e. re-engage switch
f. ON/OFF switch, cutting system.
2. Steering wheel
3. Choke control
4. Cutting height adjustment lever
5a. Forward speed pedal
5b. Reverse speed pedal
6. Parking brake lever
7. Brake pedal
8. Transmission disengagement lever
OPERATION
Fig. 11
OPERATION AND DESCRIPTION
(FIG. 11)
TOGGLE SWITCH CUTTING SYSTEM (f)
The mower clutch switch is secured in the off position,
in order to avoid accidental engagement. To engage, pull
up the switch lever, and place it in the ON position; this
actuates the cutting system clutch, which drives the
blades (fig.16).
Fig. 16
MAN/AUTO SWITCH (d)
When in AUTO position, the automatic control of the
grass collector filling is set. When the collector is full
with grass clippings, the overload protection switch
located inside the grass collector will be mechanically
activated and the audible warning buzzer signal cycle
should start after the 1 st second. After a 3 seconds
period both the buzzer the cuting system will stop
operation.
If it is the MAN position, then the overfill switch is
disabled and the collector tunnel could severely clog.
RE-ENGAGE SWITCH (e)
This switch should be pressed to re-activate the MAN/
AUTO switch, after the grass collector is emptied.
SEAT ADJUSTMENT (FIG. 12)
In order to adjust the seat, proceed to the following
steps:
1. loosen the thumb screw.
2. move the seat forward or backward to the
desired position.
3. tighten thumb screw securely.
Fig. 12
To Next Page
Loading...
