24
TO REMOVE MOWER (See Fig. 37)
Mower will be eas i er to re move from the right side of trac tor.
• Remove center chute as described previously.
• Place attachment clutch in “DISENGAGED” position.
• Lower attachment lift lever to its lowest position.
• Remove cable (H) by depressing tabs (I) and removing
cable end from bracket (J).
• Remove mandrel cover (Q)
• Remove mower belt from clutch pulley (M).
• Dismantle the retainer spring (E) and remove the lever.
• Dismantle the retainer spring (A) and remove the lever.
• Dismantle the retainer spring (D) and remove the lever.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
• Slide mower out from under right side of tractor.
TO INSTALL MOWER
• Push in the mower deck under the tractor.
• Assemble in the reverse order to dismantling.
Fig. 37
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
• Depress brake pedal fully and set parking brake.
• Place attachment clutch in “DISENGAGED” position.
• Turn ignition key to “STOP” and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
D
E
A
M
Q
J
I
H
CAUTION: Attachment lift lever is
spring loaded. Have a tight grip on
rod and release slowly.
TO REMOVE CENTER CHUTE (See Fig. 36)
• Remove bagger assembly.
• Remove wingnuts (A).
• Slide center chute (B) out of rear of tractor.
• Assemble in the reverse order to dismantling.
A
B
Fig. 36
To Next Page
Loading...
