26
Fig. 42
SERVICE AND ADJUSTMENTS
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
Fig. 43
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 42)
MOWER DRIVE BELT REMOVAL
• Park tractor on a level surface. En gage parking brake.
• Lower attachment lift lever to its lowest position.
• Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck
surface.
• Remove belt from electric clutch pulley (M), both man-
drel pulleys (R) and all idler pulleys (V).
MOWER DRIVE BELT INSTALLATION
• Install belt around all mandrel pulleys (R) and around
idler pulleys (V) as shown.
• Install belt onto electric clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
• Raise attachment lift lever to highest position.
M
V
R
E
H
J
C
G
D
F
A
B
TO REPLACE MOTION DRIVE BELT
(See Fig. 43)
BELT REMOVAL -
1. Park tractor on a level surface. En gage parking brake.
CAUTION: Ensure ignition key is removed while
working on tractor.
2. Remove bagger assembly.
3. Remove center discharge chute as previously described.
4. Remove mower deck. (See “TO REMOVE MOWER”
section in this manual.)
5. Disconnect clutch wire harness (A).
6. Remove anti-rotation link (B) on right side of tractor.
7. From the rear of the tractor, work through the backplate
and remove the mower drive belt from the transaxle
pulley (F) and rear idler pulleys (D).
8. Remove belt from middle idler pulleys (C).
9. Work the belt off of the engine pulley (G) and around
the belt guide (G).
BELT INSTALLATION -
1. Start the belt from above steering support plate (H) on
the left side of the steering shaft.
NOTE: Ensure the belt is over the top of the clutch/brake
pedal shaft (J).
2. Work the belt onto the engine pulley (G) and under the
belt guide (E).
3. Reinstall anti-rotation link (B) on right side of tractor.
Tighten securely.
4. Reconnect clutch harness (A).
5. Ensure belt is in all pulley grooves and in side all belt
guides and keep ers.
IMPORTANT: Check belt to ensure proper routing in all
mower pulley grooves and guides.
6. Install mower. (See “TO INSTALL MOWER” section in
this manual.)
To Next Page
Loading...
