Husqvarna FS 600 E - Page 19

7. Turn the water tap on the blade guard to adjust the
water supply.
To connect the external water supply
WARNING: Make sure that the cutting
blade is slightly above the ground when you
turn the water tap to adjust the water.
1. Connect an external water hose to the water inlet
(A). Put the external water hose in the hose holder.
B
A
2. To start or stop the water, push the water valve (B)
or turn the water tap (C) on the blade guard.
C
3. To adjust the water supply, push the water valve or
turn the water tap on the blade guard.
To engage and disengage the parking
brake
1. Disengage the parking brake (A) to move the
product.
B
A
2. Engage the parking brake (B) to hold the product in
position.
To start the product
WARNING: Make sure that the cutting
blade is slightly above the ground.
1620 - 003 - 28.02.2022 19