English – 15
MAINTENANCE
Changing the oil
The engine oil should be changed each year and every 25
working hours.
When changing the oil proceed as follows:
• Empty the fuel tank by running the machine until the tank
is empty.
• Disconnect the ignition lead from the spark plug.
• Unscrew the oil filler cap.
• Use the oil pump (accessory) to empty the oil tank.
Ask where you can dispose of surplus engine oil at your
local petrol station.
• Fill with new engine oil of a good quality. See the Technical
data section.
• Check the oil level with the dipstick on the oil filler cap.
• The oil filler cap must be completely screwed down to give
a correct picture of the oil level. If the oil level is low, fill
using engine oil up to the upper level on the dipstick.
• Screw on the oil filler cap.
Below you will find some general maintenance
instructions.
Daily maintenance
1 Check that the stop function works safely.
2 Brush leaves, grass and the like off of the lawn mower.
The underside of the mower deck should also be cleaned
after each use, to prevent a buildup of grass clippings.
3 Check the oil level.
4 Clean the air intake on the starter. Check the starter and
starter cord.
5 Check that nuts and screws are tight.
6 Check the cutting attachment. Never use blades that are
dull, cracked or damaged.
Weekly maintenance
1 Clean the air filter. Replace if necessary.
2 Clean the spark plug. Check that the electrode gap is 0.50
mm.
3 Clean the cooling fins on the cylinder.
At least once a year
1 Carry out annually service at authorised dealer (at least
once a year or every 30 hours).