ASSEMBLING AND ADJUSTMENTS
12 – English
Mulching
1 Lift the back shield and remove the grass bag (if
equipped).
2 Insert the mulch plug into the collector channel.
3 Allow the back shield to close and ensure the back
shield is firmly shut against the mulch plug.
Rear-side discharging
1 Lift the back shield and remove the mulch plug or
grass bag (if equipped).
2 Close the back shield to allow the machine to
discharge material to the left of the machine while
cutting.
Cutting height
The cutting height can be adjusted to 9 (1-9) different
positions.
Raise wheels for low cut and lower wheels for high cut.
Adjust cutting height to suit your requirements. Medium
position is best for most lawns.
• To change cutting height, squeeze height adjuster
lever toward the wheel. Move the wheel up or down to
suit your requirements. Set the same height at all four
corners.
• The adjuster lever is spring loaded.
Filling with oil
• The oil tank is empty at delivery. Fill the oil slowly with
the included oil. See instructions under the heading
Maintenance.
To Next Page
Loading...
Need help?
General
