ASSEMBLING AND ADJUSTMENTS
English – 7
General
Fitting the handlebar
Take care not to damage the cables and wires when you
fold up the handlebar.
Fold up the upper section of the handlebar by:
1 Fold in the engine brake handle towards the
handlebar.
2 Lift up the handlebar until the handlebar's upper
tubular construction comes directly opposite to the
handlebar's lower section. Tighten the knob correctly.
Cutting height
The cutting height adjustment is spring assisted. The
cutting height can be adjusted in five different steps.
• To lower the cutting height move the lever to the left
and then forward.
• To raise the cutting height move the lever to the left
and then backward.
!
Important Prevent unintentional starting
by removing the ignition cable from the
spark plug.
CAUTION! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
To Next Page
Loading...
