4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Apply tension to the saw chain. Refer to
Maintenance on page 25
for instructions.
9. Tighten the bar knob.
To install the battery charger (40-C80)
on the wall
CAUTION: Do not use an electric
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary.
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
Operation
Introduction
WARNING: Read and understand the
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the chain brake (A) to make sure that
it operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard (B) to make
sure that it is not damaged.
3. Do a check of the power trigger and the power
trigger lockout (C) to make sure that they operate
correctly and that they are not damaged.
4. Do a check of the keypad (D) to make sure that it
operates correctly.
5. Make sure that there is no oil on the handles (E).
6. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
7. Do a check of the chain catcher (F) to make sure
that it is attached correctly.
8. Do a check of the chain tension (G).
9. Charge the battery (H) and make sure that it is
correctly attached to the product.
10. Make sure that the saw chain stops when you
release the power trigger.
To Next Page
Loading...
