Husqvarna PZ 29 - Anti-scalp Rollers; Park Brake Adjustments

D
A
C
B
3,175
cm
5. If adjustments are needed, loosen B jam nut
and turn A jam nut until the correct distance
is achieved. Retighten B jam nuts against A
jam nuts.
6. Engage the park brake. Measure the distance
between the D brake bolt and the brake
swivel. The distance must be 3,175 mm -6,35
mm.
7. If adjustments are needed, loosen C jam
nut. Turn the brake bolt until the distance is
correct. Retighten C jam nuts.
Gap with
park brake
engaged
Anti-scalp Rollers
Anti-scalp rollers keep the deck in the proper
position to help prevent scalping in most terrain
conditions. Do not adjust the rollers to support the
deck.
IMPORTANT INFORMATION Adjust anti-scalp
rollers with the mower on a at level surface.
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.
Anti-scalp rollers can be set in three positions.
• Upper position 38 to 64 mm grass
• Middle position 64 to 102 mm grass
• Lower position 102 to 128 grass
The rollers must be approximately 6,35 mm from
ground. Do not adjust the rollers to support the
deck.
Park Brake
Visually check that no damage is found on the
lever, links, or switch belonging to the park brake.
Perform a standstill test and check that there is
sufcient braking.
WARNING! Faulty adjustment will result
in reduced braking and can cause an accident.
Park Brake Adjustments
1. Using a jack stand, raise the rear of the
mower up off the ground. Make sure the
machine is securely supported.
2. Remove the rear tire assemblies.
3. Release the park brake.
4. Measure the distance from the swivel to the
washer. The measurement must be 4,445 cm
on both the right and left side brake linkage
assemblies.
28
MAINTENANCE