4. To release the parking brake, press the parking
brake pedal again.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on page
15
.
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, refer to
Technical data on
page 29
). Move the product forward at low speed. If
the grass is not too high and thick, you can get a
good cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the Bioclip
®
function.
Maintenance
Introduction
WARNING: Before you do any
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
1. PREPARE THE PRODUCT First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the battery. O
Do a check of the blades. O
Do a check of the belts and pulleys. O O
Do a check of the steering chain of the inner side of the frame tunnel. O
Do an inspection, lubricate and adjust all wires. O
Make sure that the tire pressure is correct. Refer to
Tire pressure on page 21
. O O
Make sure that all screws and nuts are tightened with the correct torque. O
Lubricate the operators seat. O
Lubricate the wheels and blade bearings on the cutting deck. O O
Lubricate the pedals on the inner side of the frame tunnel. O
Lubricate the belt tensioner. O
Remove the wheels and lubricate the wheel axles. O
2. ENGINE First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the fuel hose. Replace if it is necessary. O
Replace the fuel filter. O
Replace the air filter. Clean O
Do an inspection of the cooling fins on the hydrostatic transmission. O
1590 - 006 - 20.10.2021 15
To Next Page
Loading...
