6. Pull the spring eye to loosen the spring for the drive
belt tension.
7. Put the spring eye in the holder on the tension arm
for the drive belt.
8. Remove the drive belt and put it in the belt holder.
9. Put a wooden block between the equipment frame
and the chassis. This makes sure that the cutting
deck does not spring back when removed.
WARNING:
Be careful. Risk of injury if
your hand is caught between the
equipment frame and the chassis.
10. Remove the 2 screws on the equipment frame.
11. Hold the front edge of the cutting deck with two
hands and pull it out.
12. Remove the wooden block.
13. Attach the cutting deck in opposite sequence.
Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
Fuel safety
on page 9
).
854 - 003 - 14.11.2018 11
To Next Page
Loading...
