Maintenance
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Maintenance
Daily maintenance
before operation
Maintenance
interval in
hours
25 50 100
Make sure that nuts and screws are tightened *
Make sure that there are no fuel or oil leaks *
Clean as given in
To clean the product on page 16
X
Clean the inner surface of the cutting deck, around the blades X
Clean around the muffler X
Make sure that the cold air intake of the engine is not blocked X
Make sure that the safety devices are not defective X
Examine and do a test of the brakes *
Do a check of the engine oil level X
Do a check of the oil level in the transmission X
Do a check of the steering wires X
Examine the blades in the cutting deck X
Clean the cutting deck, below the belt covers and below the cutting
deck
X X
Make sure that the tire pressure is correct X X
Do a check of the parking brake X
Replace the engine oil X X
Replace the oil filter X X
Clean the air filter X
Replace the air filter X
Replace the fuel filter X
Replace the spark plug X
Do a check of the parallelism of the cutting deck X X
Lubricate the belt adjuster. X X
Lubricate according to the lubrication overview O O
854 - 003 - 14.11.2018 15
To Next Page
Loading...
